3
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
OUTLINE OF THE MACHINE
3 - 45
7. Separation Self-separation by transfer belt and 2nd
transfer roller
8.
Photoconductive
drum cleaning
Method Blade cleaning
Recovered
toner
Non-reusable
9. Transfer belt cleaning Blade cleaning
10.Discharge LED array (red)
11.Fusing Method External IH heating fusing and heat
pipe roller soaking systems
Fuser roller
side
Heat pipe roller:
Roller in which a heat pipe is
embedded (ø17.4)
Fuser roller:
Sponge roller (ø48.5)
Fuser belt:
PFA tube belt (ø60)
IH coil: 1 coil
• 200 to 1240W (for MJC/MJD)
• 200 to 1100W (for NAC/NAD,
ASU, ASD, ARD, AUC/AUD,
CND)
Pressure
roller side
Pressure roller:
Silicon rubber roller,
(Surface-PFA tube)(ø50)
Heater lamp:
• 300 W x 2 (for NAC/NAD)
• 300 W x 2 + 800 W x 1 (for
MJC/MJD)
• 300 W x 2 (for ASU, ASD, ARD,
AUC/AUD, CND)
Pressure roller:
Silicon rubber roller,
(Surface-PFA tube)(ø50)
Heater lamp:
•300 W x 2
Cleaning None
Heater
temperature
ON/OFF control and power control by
thermopile/thermistor
Heater IH coil + Heater lamp
Process e-STUDIO5540C/6540C/6550C e-STUDIO5560C/6560C/6570C
To Next Page
Loading...
