8-108Trio BASIC Commands
System Parameters and Commands
Trio Motion Technology
NETSTAT
Type:
System Parameter
Description:
This parameter stores the network error status since the parameter was last cleared
by writing to it. The error types reported are:
NEW
Type:
System Command
Description
Deletes all the program lines in the controller memory. It also may be used to
delete the current
TABLE
entries.
Note:
NIO
Type:
System Parameter (Read Only)
Description:
This parameter returns the number of inputs/outputs fitted to the system, or con-
nected on the IO expansion CAN bus.
Bit Set Error Type Value
0TX Timeout 1
1 TX Buffer Error 2
2
RX CRC Error 4
3RX Frame Error 8
NEW
Deletes the currently selected program
NEW progname
Deletes a particular program
NEW ALL
Deletes all programs in memory
NEW "TABLE"
Delete TABLE (In this case ONLY the program name “TABLE”
must be in quotes)
To Next Page
Loading...
