10-74Support Software
Project Autoloader
Trio Motion Technology
Project Autoloader
Trio Project Autoloader is a stand alone program to load projects created using
Motion Perfect 2 onto a Trio Motion Coordinator.
The program is small enough to fit onto a 1.44MByte floppy disk and is intended
for easy loading of projects onto controllers without the need to run Motion Per-
fect and so allows OEM manufacturers to update customers equipment easily.
Operation of the program is controlled using a script file which gives a series of
commands to be processed, in order, by the program.
Using the Autoloader
General
The autoloader is primerally intended to be used from a floppy disk to update
controllers already installed in equipment to allow OEM manufacturers to update
customers equipment easily. It can also be used from a hard disk or CD-ROM.
Script File
The commands to be executed are held in a script file AutoLoader.tas which must
be in the LoaderFiles directory.
Project
The project to be loaded using LOADPROJECT is in the form of a normal Motion
Perfect 2 project. This consists of a directory containing a project definition file
and TrioBASIC program files. The directory must have the same name as the
project definition file less the extension.
i.e. project definition file TestProj.prj, directory TestProj
The project directory must be in the LoaderFiles directory.
Tables
Any tables to be loaded must be in the form of *.lst files produced by Motion Per-
fect 2.
Normally these table files will be in the LoaderFiles directory.
Extra Programs
Programs which need to be loaded using LOADPROGRAM because they are not in
the project being loaded (or if no project is being loaded)
Normally these program files will be in the LoaderFiles directory.
To Next Page
Loading...
Need help?
General
