Setting
RFID channels — overview of commands
Hans Turck GmbH & Co. KG | T +49 208 4952-0 | more@turck.com | www.turck.com
07.00 | 2022/09 | 133
8.8.14 Command: Get UHF read/write head status/error
NOTE
The command is only available for UHF applications.
The Get error/status of UHF read/write head command enables error/status messages of a
connected UHF reader to be read.
NOTE
The command code for fast processing with the loop counter is 0x2042 (hex.) or
8258 (dec.).
See description of the output data, p. [}105].
Request
Loop counter See description of the output data
Command code 0x0042 (hex.), 66 (dec.)
Read/write head address Not required
Length UID/EPC Not required
Start address Address in the Get Status response record
Length Length of the data to be read from the Get Status response
record
0: Read entire Get Status response record
Timeout See description of the output data
Write fragment No. 0
Read fragment No. See description of the output data
Write data Not required
To Next Page
Loading...