turck TBEN-RFID Series - Command: Restore Settings UHF Read;Write Head

Setting
RFID channels — overview of commands
Hans Turck GmbH & Co. KG | T +49 208 4952-0 | more@turck.com | www.turck.com
07.00 | 2022/09 | 167
8.8.33 Command: Restore settings UHF read/write head
NOTE
The command is only available for UHF applications.
The Restore settings UHF read/write head command restores the parameters of a connected
UHF reader from a backup (e.g. after a device swap). Type and firmware version must be
identical for both readers. To execute the command, a backup must be created beforehand via
the Backup settings UHF read/write head command.
See description of the output data, p. [}105].
Request
Loop counter See description of the output data
Command code 0x1000 (hex.), 4096 (dec.)
Read/write head address See description of the output data
Length UID/EPC Not required
Start address Not required
Length Not required
Timeout See description of the output data
Write fragment No. 0
Read fragment No. See description of the output data
Write data Not required
See description of the input data, p. [}100].
Response
Loop counter See description of the input data
Response code 0x1000 (hex.), 4096 (dec.)
Length Not required
Error code See description of the input data
Tag in
detection range
See description of the input data
Data (bytes) available See description of the input data
Tag counter See description of the input data
Write fragment No. 0
Read fragment No. See description of the input data
Read data Not required