Operation
Use fragmentation
Hans Turck GmbH & Co. KG | T +49 208 4952-0 | more@turck.com | www.turck.com
07.00 | 2022/09 | 219
Enter the second 128 bytes of write data under Output buffer.
Under Write fragment No., enter the sequential number of the next fragment with the
write data (here: 2).
It is written directly if a tag is in the detection range. The data is stored in the TBEN module if
there is no tag in the detection range.
The tag must stay in the detection range until the command is fully executed. The device out-
puts a fault signal if the tag is removed from the detection range before the command has
been completed.
Fig.134: Fragmentation — write second fragment