turck TBEN-RFID Series - Page 87

Setting
RFID channels — parameter data
Hans Turck GmbH & Co. KG | T +49 208 4952-0 | more@turck.com | www.turck.com
07.00 | 2022/09 | 87
Designation Meaning
Deactivate diagnostic HF read/
write head tuning (DXD)
0: No (diagnostic messages of the read/write head on)
1: Yes (diagnostic messages of the read/write head off)
HF: Idle mode (HFIDLEMODE) Defines which data is to be displayed in idle mode (not available in the EDS file)
0: UID
1: 8 bytes of user memory
2: UID and 8 bytes of user memory
3: UID and 64 bytes of user memory
4: Deactivated
Command repetitions in the
event of a fault (CRET)
Number of command repetitions after a fault signal, default setting: 2
HF: Command in Continuous
Mode (CCM)
0x01: Inventory
0x02: Read
0x03: Tag info
0x04: Write
HF: Length in Continuous Mode
(LCM)
Number of bytes that still have to be read or written in Continuous Mode, default
setting: 8
HF: Address in Continuous Mode
(ACM)
Start address of the UID or the USER memory area on the tag to be read or writ-
ten, default setting: 0
HF bus mode: Activate read/
write head … (XCVR0…XCVR31)
0: No (deactivate read/write head)
1: Yes (activate read/write head)
In HF bus mode all connected and addressed read/write heads are deactivated
by default and must be activated in the parameters.
Length of read data (RDS) Size of the read data, default setting depends on the selected interface and
fieldbus
Length of write data (WDS) Size of the write data, default setting depends on the selected interface and
fieldbus