558
Model
Code Page
220.06.1994 6000---8400 39
DPS--- EXTRA BUTTONS, FITTING
(3)
--- Draw the wires along the cab RH side corner
(together with the other wires) to the rear part of the
lever console and inside the rear horizontal beam
to the socket bracket 23.Fastenthewireswith
tape.
Connect the wires to socket 24 according to the
figure. Fasten the socket.
--- Make a wire between the socket and push buttons
on the implement.
For this you need a rubber cable, cross section 3
x1,5 mm
2
, measure a suitable length.
--- To the push button ends of the wires is fitted con-
nectors 28, and a contact plug 26 to the other
end.
Check that the positions of the wires in the plug 26
correspond the positions of the wires in the socket
24.
--- pin 4, to buttonb ,change down (blue)
--- pin 6, supply to both buttons.
(green or brown)
--- pin 7 to button y , change up (black)
Fit the push buttons 29 on the implement (Note!
The lower parts of the buttons must be protected
from water, e.g. in a suitable box), and connect the
wires.
1 32948400 Lisäkytkimet, DPS Extra strömbr.,DPS Extra switches, DPS Zusätzliche Schalter, DPS
15 1 32862600 .Johdin Ledning Wire Leitung
17 2 32908300 .Painokytkin Tryckknapp Push button Druckschalter
18 1 32908200 .Kehys Ram Frame Rahmen
1 32948500 Lisäkytkytk., DPS Extra strömbr.,DPS Extra switches, DPS Zusätzliche Schalter, DPS
työkone redskap implement Anbaugerät
23 1 32236700 .Kannatin Hållare Support Halter
24 1 31720300 .Pistorasia Stickdosa Plug socket Steckdose
25 3 HD9042 .Ruuvi Skruv Screw Schraube
26 1 31702900 .Pistoke Stickkontakt Contact plug Steckkontakt
27 3 SA1776 .Liitin Anslutning Connector Anschluß
28 4 SA1757 .Liitin Anslutning Connector Anschluß
29 2 30572200 .Painokytkin Tryckknapp Push button Druckschalter
To Next Page
Loading...
