715
Model Code Page
42. Gearbox
1. 4. 1997
6000--8750 423 11
15. 5. 1996
2444
22. Fit the AVO---shaft into the gearbox through the side ope-
ning and carry out the following steps:
--- Fit the front circlip of the rear bearing into its groove.
--- Fit the rear bearing into place against t he circlip.
--- Fit the rear circlip of the rear bearing.
--- Tap at the shaft front end until the shaft is fully home.
---Fitthefrontbearing.
2463
--- Fit the front and rear bearing circlip into the grooves on the
shaft.
B. Fitting selector forks
2442
1. Fasten the sliding pieces on the forks with a little grease. Fit
the forks for gears 1---2 and 3---4 onto the input shaft and sup-
port the forks in the upper position with a selector fork rail.
2. Fit the sliding pieces on the M---H fork and fit the fork onto
the bevel pinion shaft.
Note! From tractor ser. no. 661937 the forks and the sliding
pieces have been c hanged. In connection with repair works,
the latest forks and sliding pieces must be fitted on the tractor
in place of the earlier parts despite of the condition of the ear-
lier parts. This concerns also the F---R fork.
2457
3. Fasten the rail to the LL---range fork if detached. Note! The
groove on the shaft upwards. The locking pin is fitted with the
split end to one side.
2458
ETV 894 080
4. Fit the spring, ball and tool ETV 894080 into the LL---range
fork. The tool holds the ball and spring in place. Fit the LL---
range fork with its rail into the gearbox (latest LL forks have
also the sliding pieces).
To Next Page
Loading...
