Valtra 6550 - Page 782

729
Model Code Page
1. 11. 1998
6000--8750
5440
44. Quick---shift gear, reverse shuttle
and 4WD clutch
15. 5. 1996
4 4 . 2 3 --- s t e p q u i c k --- s h i f t g e a r D e l t a P o w e r s h i f t
Part no Description
A
ETV 892 180 Drift for fitting oil seal and needle bearing inside input s haft front end (see 2---step quick---shift gear)
ETV 893720 Plate for fitting quick---shift gear front oil seal (front axle ZF on 305---665)
ET 893 480 Support plate for front end frame, 2 pcs (s ee 2---step quick---shift gear)
ETV 894 200 Drift for fitting oil seal and needle bearing inside DPS input shaft front end (transmission 650)
B
ETV 893700 Sleeve for fitting oil seal inside the middle sun gear (PTO 205---665)
ETV 894030 Sleeve for fitting planetary carrier ball bearing (Hydraulic power lift 205---665)
ETV 892 180
ETV 893 700
ETV 893 720
ETV 894 030
ETV 894 200
44.3 Mechanical reverse shuttle
A
ETV 892 180 Drift for fitting needle bearing/sealing ring on input shaft (Gearbox 505---905).
Only on tractors without quick---shift gear.
ETV 894 200 Drift for fitting needle bearing/sealing ring inside reverse shuttle input shaft front end (transmission 650)
Only on tractors without DPS gear.
ETV 892 180
ETV 894 200