EasyManua.ls Logo

Vertical SBX IP - Page 118

Vertical SBX IP
338 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Station Group Assign (PGM 190/191) 1-104
Chapter 1: SBX IP Online PC Admin
SBX IP - PC Admin Guide
Circular/Terminal Group Attributes (PGM 191)
ITEM RANGE DEFAULT REMARK
VMIB Announce 1 Timer 000-999 015
(sec)
If this timer expires after a call comes into the group, the
system announces the greeting, if one exists.
VMIB Announce 2 Timer 000-999 000
(sec)
If this timer expires after a call comes into the group, the
system announces the VMIB, if assigned.
VMIB Announce
Location 1
00-70 00 (not
assigned)
This location is used to announce a greeting when the
VMIB Announce 1 timer expires.
VMIB Announce
Location 2
00-70 00 (not
assigned)
This location is used to announce greeting when the
VMIB Announce 2 timer expires.
VMIB Announce 2 Repeat 000-999 000
(sec)
The VMIB announce 2 is repeated when this timer expires
(000 = not assigned).
VMIB Announce 2 Repeat
Enable/Disable
ON/OFF OFF This is used to enable or disable the VMIB Announce 2
Repeat.
Overflow Destination Sta #./
HUNT #./
VMIB #/
SYS SPD
#
-- The call to a station in the group will continue to route until
answered or each station in the group has been tried. The
call will remain at the last station in the group or will be
passed to this overflow station/group/VMIB.
Overflow Timer 000-600 180
(sec)
If this timer expires after a call comes into the group, the
call is routed to the overflow destination.
Wrap-up Timer 002-999 002
(sec)
A station in a hunt group is maintained in a busy state for
a minimum of six seconds after any call and for hunt group
calls for the assigned wrap-up time.
No Answer Timer 00-99 15
(sec)
In circular hunt, calls to a station in the group will go to the
station, if unavailable or unanswered in this no answer
time, the call is directed to the next station in the group.
Pilot Hunt ON/OFF ON A circular hunt group can be assigned with a pilot number
(the station group) so that only calls to the pilot number
will hunt.
Alt if no Member ON/OFF OFF If there is no member on duty, an ICM call will be dropped
or an incoming CO call will be routed to the Attendant.
Release 3.5
June 2010

Table of Contents

Related product manuals