TITANUS MICRO·SENS
®
Glossary
TMS_A_Glossar-e – Data: 01/09
Fire monitor
Part of a →central fire panel to identify fire in the
protected area.
Fire section
Isolated section in a building (special
construction) which avoids or slows down the
spreading of a fire to a neighboring section.
Fire-resistant collar Constructions which avoids flame/smoke
spreading in cable ducts as well as in recesses
and break-through for wiring in walls and ceilings.
I
Interactive detector Detector series with highest detection reliability for
evaluation and decision logistics with interactive
signal processing based on programmable
algorithms. The detectors can be parameterized;
they can be optimally programmed in software for
the requirements of the installation location.
Interference Interferences in smoke detection installations are
external values which can impair the proper
functioning of a smoke detection installation.
L
Line module By means of line modules (AnalogPLUS
®
or
interactive) TITANUS MICRO·SENS
®
can be
connected to the AlgoRex
®
-smoke detection
system.
LOGIC·SENS Via the LOGIC·SENS switch the intelligent signal
processing can be activated. It permits analysis of
the measured smoke level by comparing the
smoke data with known parameters, thus
detecting interferences and avoiding false alarms.
Loop line
→Detection line which forms a loop from the
central fire panel via the →smoke detectors and
back to the central fire panel to increase operation
reliability.
M
Monitoring area Area which is monitored by an automatic smoke
detector.
Monitoring window The normal air flow lies within an adjustment
range between a defined upper and lower value.
This range is the monitoring window.
N
Nominal gap width Maximum gap in the housing of the detonation
prevention device without an ignition spark being
flashed from the device to the potentially
explosive area.
To Next Page
Loading...
Need help?
General
