WAGNER TITANUS - Connecting Parallel Displays

TITANUS MICRO·SENS
®
Installation
MS_A_05-en-e Data: 01/09 5 – 25
5.10 Parallel displays
5.10.1 Connecting the parallel displays to
TITANUS MICRO·SENS
®
Device base unit
1 4
Fig. 5.23: Connection of parallel display to TITANUS MICRO·SENS
®
To connect the parallel display, take the following steps:
n
Using a screwdriver loosen the four screws on the TITANUS
MICRO·SENS
®
detection unit.
o
Feed the fire alarm cable through the cable entry on the
TITANUS MICRO·SENS
®
device base unit.
p
Feed the wires to the terminal block on the base unit according to
the switching plan (see Fig. 5.25).
q
Refit the detection unit by using a screwdriver to screw the four
screws on the detection unit of the device cover down firmly
.