WAGNER TITANUS User Manual

TITANUS MICRO·SENS
®
Installation
MS_A_05-en-e Data: 01/09 5 – 37
5.13 Data Logging
A simple device check can be run using the diagnostic tool. By reading
messages and statuses, the diagnostic program offers a considerably
simplified service.
DIAG 3 can be fastened to the TITANUS MICRO·SENS
®
by an device
bracket or attached in a straight line (±10°) of up to 3 m distance to the
infrared interface.
The data are read via an infrared interface on the TITANUS
MICRO·SENS
®
using the DIAG 3 which is connected to the USB inter-
face on the PC by a USB cable.
Commissioning of the diagnostic software is described in Chapter 7
“Commissioning”.
Connection cable
USB cable
USB-interface
PC
TITANUS MICRO · SENS
®
Infrared interface for
“DIAG” connection
DIAG3
Fig. 5.33: Connecting a PC to the TITANUS MICRO·SENS
®
It is recommended that, in order to check the device settings later, they
are stored and archived after commissioning.
TIP

WAGNER TITANUS Specifications

General

Power Supply	24 V DC
Operating Temperature	-20°C to +60°C
Alarm Output	Relay contacts
Certification	VdS, EN 54
Humidity Range	10% to 95% (non-condensing)