Waters GCT Premier - The Tune Window Tuning Controls; The Source Tab

The Tune window tuning controls B-21
The Tune window tuning controls
In the tuning control tabs you set the parameters used to tune the instrument.
Five tabs are provided:
• Source tab
•Inlet tab
• DRE tab
• Calibration tab
•Engineer tab
Tip: The tuning control tabs can be hidden by clicking View > Tuning
Parameters. Click the command again to display the tuning control tabs.
See also: Hide/display the tuning parameters on page B-19.
The Source tab
The Source tab contains the controls for the instrument’s source parameters.
The contents of the Source tab varies, depending on the source selected by
clicking Ion Mode on the menu bar. The following sections detail the
parameters available on each version of the tab.