Changing the EI/CI outer source assembly 2-9
5. Fit the top cover to the instrument.
6. Fit the inner source.
See also: Installing the EI/CI inner source on page 2-4.
7. Push the GC interface into place, and tighten the two thumbscrews.
8. Open the reference reservoir valve.
9. If required, fit the GC column to the instrument.
See also: Installing the GC column on page 6-9.
10. In the MassLynx Tune window, click Vacuum > Pump Source, and
confirm that the Vacuum LED shows green.
To Next Page