Weber Geset ALPHA V40 User Manual

Chapter 4 Inputs / Outputs ALPHA V40
Version 18.07.06
31
Use the plastic shunts (actually contain metal for bridging two pins of jumper) for the
configurations. The possible settings are shown on the table as follows:
Fig. 4-5: without enclosure cover (top view)
Config. Sensor - Typ Drawing
Jumper setting
(see Fig. 4-4)
1
NPN-Sensor (settable/ 1 output)
detection: leading edge
BC DE GH IJ KL
2
NPN-Sensor (settable/ 1 output)
detection: trailing edge
BC DE GH IJ LF
3
PNP-Sensor (settable/ 1 output)
detection: leading edge
AB CD GH IJ KL
4
PNP-Sensor (settable/ 1 output)
detection: trailing edge
AB CD GH IJ LF
5
NPN-Sensor (antivalent/ 2 outputs)
detection: leading edge
BC DE GH
NPN-Sensor (antivalent/ 2 outputs)
detection: trailing edge
6
NPN-Sensor (bipolar)
detection: *changeable on sensor
BC DE HI
PNP-Sensor (bipolar)
detection: *changeable on sensor
7
PNP-Sensor (antivalent/ 2 outputs)
detection: leading edge
AB CD GH
8
PNP-Sensor (antivalent/ 2 outputs)
detection: trailing edge
AB CD HI
* The mode „leading edge“ or „trailing edge“ is set via button on the sensor itself and not with
jumper inside the controller.

Weber Geset ALPHA V40 Specifications

General

Brand	Weber
Model	Geset ALPHA V40
Category	Industrial Equipment
Language	English