GENERAL
M6060, M7060, WSM
G-32
Adjusting Toe-in
1. Park tractor on a flat place.
2. Turn steering wheel so front wheels are in the straight ahead
position.
3. Lower the implement, lock the park brake and stop the engine.
4. Measure distance between tire beads at front of tire, hub height.
5. Measure distance between tire beads at rear of tire, hub height.
6. Front distance should be shorter than rear distance.
7. If not, adjust tie-rod length.
Toe-in Adjustment
1. Remove the snap ring (1).
2. Loosen the tie-rod nut (3).
3. Turn the tie-rod joint to adjust the rod length until the proper
toe-in measurement is obtained.
4. Retighten the tie-rod nut (3).
5. Attach the snap ring (1) of the tie-rod joint.
9Y1210828GEG0029US0
Draining Fuel Tank Water
1. Loosen the drain plug (2) at the bottom of the fuel tank (1) to let
sediments, impurities and water out of the tank. Finally tighten
up the plug.
• If the fuel contains impurities, such as water, drain the fuel
tank at shorter intervals.
• Drain the fuel tank before operating the tractor after a long
period of storage.
• The fuel tank is made of plastic. Be careful not to
overtighten the bolts.
9Y1210828GEG0030US0
Cleaning Inner Air Filter (CABIN Model)
1. Remove the knob bolt (2) and pull out the filter (1).
2. Blow air from the direction opposite to the filter's normal air flow.
Pressure of compressed air must be under 205 kPa (2.1
kgf/cm
2
, 30 psi).
9Y1210828GEG0031US0
Toe-in (b–a) Factory specification
2.0 to 8.0 mm
0.08 to 0.31 in.
Tightening torque Tie-rod nut
167 to 196 N·m
17 to 20 kgf·m
123.2 to 144.6 lbf·ft
(1) Snap Ring
(2) Tie-rod Joint
(3) Tie-rod Nut
(4) Rod End
(a) Wheel-to-wheel distance at front
(b) Wheel-to-wheel distance at rear
(c) "FRONT"
(1) Fuel Tank (2) Drain Plug
(1) Inner Air Filter (2) Knob Bolt
To Next Page
Loading...
