Page 6 160337-000 Rev D, 30 September, 2013 Xiotech—Proprietary
ISE User GuideUser Guide Introduction
Reduced Air Flow
Installation of the equipment in a rack should be such that the amount of air flow required for safe operation of
the equipment is not compromised.
Mechanical Loading
Mounting of the equipment in a rack should be such that the rack and supporting floor structure weight
capacities are not compromised.
Circuit Overloading
Consideration should be given to the connection of the equipment to the supply circuit and the effect that
overloading of circuits might have on over-current protection and supply wiring. Appropriate consideration of
equipment nameplate ratings should be used when addressing the concern.
Reliable Earthing
Reliable earthing of rack-mounted equipment should be maintained. Particular attention should be given to
supply connections other than direct connections to the branch circuit (for example, use of power strips).
Power Supplies
All ISE Storage Blade models have redundant power supplies. Both AC power cords must be removed before
servicing any ISE Storage Blade. All ISE Storage Blade models must be serviced only by an Authorized
Service Technician.
Safety and Emissions
All ISE Storage Blade models have been verified to the following safety certifications:
All ISE Storage Blade models have been verified to the following emissions/immunity certifications:
• FCC CFR 47 - Part 15
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
• UL60950-1 • CSA C22.2 No. 60950-1
• EC Directive 2006/95/EC • EN 60950-1
• IEC 60950-1
• CSA C108.8-M1983 • CISPR 22
• EC Directive 89/336/EEC • EN61000-3-2
• EN61000-3-3 • EN61000-4-2
• EN61000-4-3 • EN61000-4-4
• EN61000-4-5 • EN61000-4-6
• EN61000-4-8 • EN61000-4-11
• EN 50081-1 • EN 55022
To Next Page
Loading...
General