Xiotech—Proprietary 160337-000 Rev D, 30 September, 2013 Page 71
ISE Management ISE User Guide
The range for the -interval option is 15 to 1440 minutes. For Telemetry it is recommended that the interval
be allowed to default to 1440.
For example, the following command creates a subscription with an IP address destination of 10.20.30.40 and
an interval of 8 hours (720 minutes).
subscribe add -ipaddress=10.20.30.40 -interval=720
View Subscriptions
Active subscriptions can be viewed with the Orchestrator, the Web-Mgt interface, and the CLI.
Orchestrator
To view ActiveWatch subscriptions using the Orchestrator, select
All Devices
>>
ise_name
>>
ActiveWatch
>>
Subscriptions
. (See the Orchestrator User Guide.)
Web-Mgt
From Web-Mgt At-A-Glance Summary Page, pull down the System menu and select subscriptions (see
Figure 47 on page 69, reference number 1). The Subscription Summary Page appears, showing the IP
address of the default subscription to the ISE Analyzer Software Service managed by Xiotech (Figure 49
below).
Figure 49. Subscription Summary
Command Line Interface
From the CLI, enter the following command at the prompt to view a subscription to a locally installed ISE
Analyzer Software Service:
subscribe show
The existing subscriptions are displayed similar to the following example:
ipaddress=10.20.30.40, type=telemetry enabled=true, interval=1440
To Next Page
Loading...
General