Xiotech—Proprietary 160337-000 Rev D, 30 September, 2013 Page 49
Initialize and Configure ISE User Guide
3. Continue to set parameters until all desired changes are complete (use the up arrow key to retrieve previ-
ous entries).
Table 13: CLI—System Parameters
1
Entries may contain special characters except those listed in “Reserved Characters” on page 35. If an entry
is to include spaces, enclose the entire entry in quotation marks.
2
Append the --dst option to this command to specify automatic adjustment to Daylight Savings Time.
ISE System Parameters Detailed
This section describes the various system parameters of the ISE that can be customized.
System Name
The system name is an optional user-defined name for an ISE. A name is any alphanumeric string of up to
thirty-two characters. Embedded blanks and special characters (excepting “Reserved Characters” on page 35)
are permitted.
Web-Mgt Interface: To view or set the System Name from the Web-Mgt, select the System Information
Settings view (
System
>>
system info
). A name applied to an ISE is shown adjacent to the ISE icon in the
navigation pane.
CLI: To display the System Name from the CLI, use the show ise command. The System Name is changed
with the configure --name=<ise_system_name> command (“CLI—System Parameters” ). If the name
is to contain embedded blanks, enclose the character string in quotation marks as shown in the following
example:
configure --name=<“ISE System Name”>
Parameters Displayed Through the
show ise
Command
Parameter
Command to Set
1
Additional Description
System Name
configure --name=<System_Name> “System Name” on page 49
Address
configure --address=<Address> “Address” on page 50
Location
configure --location=<Location> “Location” on page 50
Contact Name
configure --contact=<Contact_Name> “Contact Name” on page 50
Contact Phone
configure --phone=<Contact_Phone> “Contact Phone” on page 50
Contact Email
configure --email=<Contact_Email> “Contact Email” on page 51
Fibre Channel Port Speed
configure --fcspeed=<Auto|2|4|8> “Fibre Channel Port Speed” on
page 52
Date, Time, Time Zone, and
auto-adjust for Daylight ti
me
configure --date=<DD-MMM-YYYY>
configure --time=<HH:MM:SS>
configure --timezone=<Zone>
2
Also see: help timezone
“System Clock Settings” on page 52
Parameters Displayed Through the
show network
Command
DHCP setting
configure --dhcp=<Enable|Disable> “Network Settings” on page 51
Port 1 IP Address, IP Mask, IP
Gateway, Connection Status
configure --ipaddress1=<x.x.x.x>
configure --netmask1=<x.x.x.x>
configure --gateway1=<x.x.x.x>
“Network Settings” on page 51
Port 2 IP Address, IP Mask, IP
Gateway, Connection Status
configure --ipaddress2=<x.x.x.x>
configure --netmask2=<x.x.x.x>
configure --gateway2=<x.x.x.x>
“Network Settings” on page 51
Wake-on-LAN setting
configure --wol=<Enable|Disable> “Wake-on-LAN (WOL) Service” on
page 51
To Next Page
Loading...
General