Xiotech—Proprietary 160337-000 Rev D, 30 September, 2013 Page 85
ISE Management ISE User Guide
View, Modify LUNs
LUNs are created during host-volume mapping. Each time a mapping is made, the ISE assigns an
incrementing LUN number (starting with 0) to the volumes seen by that host. For example, in the configuration
shown in Figure 55 on page 83,
r2_meta1
is the first volume mapped to
cc1r2_p1_ini
, so it is
LUN0
to this host.
From the Web-Mgt, LUN assignments are displayed in the Volume Summary view (
Storage
>>
summary
) or
Host Summary view (
Hosts
>>
summary
). In the CLI, LUN assignments are displayed on the console from the
show host and show volume commands.
The LUN number for a given volume on a given host can be changed as needed to meet host-LUN
configuration requirements. The following subsections detail changing the LUN using the Web-Mgt (“Web-Mgt
View, Modify LUNs”) and the CLI (“CLI View, Modify LUNs” on page 87).
Orchestrator View, Modify LUNs
To view and modify LUNs using the Orchestrator, select
All Devices
>>
ise_name
>>
Host View
>>
Mapping
.
(See the Orchestrator User Guide.)
Web-Mgt View, Modify LUNs
From the Web-Mgt, the LUNs assigned to each volume are shown on the following pages:
•
Host Summary
(
Hosts
>>
summary
) (Figure 44 on page 62)
•
Volume Summary
(
Storage
>>
summary
) (Figure 41 on page 59)
•
Detailed Host Information
, click the host on the
Host
or
Volume Summary
page (Figure 53 on page 79)
•
Detailed Volume Information
, click the volume on the
Host
or
Volume Summary
page (Figure 51 on page 77)
To change a LUN assignment:
1. Click the volume name in one of the following locations:
•
Mapping
column of the
Host Summary
page or
Volume Summary
page
• Host in the left navigation pane on the
Detailed Volume Information
page (Figure 51 on page 77)
• Volume in the left navigation pane on the
Detailed Host Information
page (Figure 53 on page 79)
To Next Page
Loading...
General