Xiotech—Proprietary 160337-000 Rev D, 30 September, 2013 Page 47
Initialize and Configure ISE User Guide
System Parameters
The configurable ISE system parameters—factory settings—should be reviewed and changed as needed.
Discussed here are:
• Using the Orchestrator interface, detailed in the Orchestrator User Guide
• Using the Web-Mgt interface as detailed in “Web-Mgt” on page 47
• Using the Command Line Interface as detailed in “Command Line Interface (CLI)” on page 45
• Explained in “ISE System Parameters Detailed” on page 49
Orchestrator
Refer to the
Orchestrator User Guide
to see what ISE system parameters can be viewed and changed
through Orchestrator.
Web-Mgt
The system parameters may be changed at any time. With the Web-Mgt, all parameter changes become
effective immediately upon clicking
SAVE CHANGES
(see Step 3 below). To view or set system parameters,
connect to the ISE using the Web-Mgt. Then perform the following steps:
1. Place the pointer over the
System
tab in the navigation bar in the ISE Management window and then select
one of the system parameter setup options from the drop-down menu as shown in Figure 37.
Figure 37. Web-Mgt Interface—System Drop-Down Menu
Setup Menu Options Parameters Description
System >> display
At-A-Glance Summary
“ISE System Monitoring” on page 103
System >> network config
DHCP setting “Network Settings” on page 51
Port 1 & 2 IP Address, IP Mask, IP
Gateway, Connection Status
“Network Settings” on page 51
Wake-on-LAN setting
“Wake-on-LAN (WOL) Service” on page 51
To Next Page
Loading...
General