Page 46 160337-000 Rev D, 30 September, 2013 Xiotech—Proprietary
ISE User Guide Initialize and Configure
The ISE 7-Series is initialized with one pool distributed across two DataPacs. To initialize the ISE and the
storage pools after skipping the initialization prompt, use the initialize command with no parameters.
View the sparing percentage in effect on a system that has already been initialized by using either of the
following commands:
•Type initialize. The console displays the following message:
Already initialized. Nothing to do. (Sparing = 20%).
•Type show datapac. The resulting console output includes the spare level in effect.
To Next Page
Loading...