Xerox 8830 Service Manual

Status Code Entry Chart (cont.)
Status
Code
J1-01
J2-02
LL-00
LL-02
LL-05
LL-06
LL-07
LL-10
Description
Toner sensor error
Out of toner.
Cartridge home sensor error
Toner cartridge could not find the home
position.
Communication error
Applies only to printers with a bit mapped
user interface (FX).
Check sum test error
Both message ROMs have failed the
checksum test immediately after power up.
Fuser oil web error
NVM count of web encoder pulses indicates
the fuser oil web has reached end of life.
Fuser oil web error
No encoder pulses are being received from
the fuser oil web.
Fuser oil web error
Web Oiler Assembly connector not
connected.
Module wrap-around error
The paper transport assembly or the
Xerographic module is disconnected.
Components
Toner sensor (A22Q1).
Main PWB(A3)
Cartridge Home Sensor (A22Q2)
Main PWB (A3)
Cartridge Drive Motor
Cartridge Drive Gear
Web oiler motor (A23MOT1)
Driver PWB (A2)
CONTROL EPROMS
Web oiler optical switch (A23S2)
Web oiler motor (A23MOT1)
Driver PWB (A2)
P/J 4, wiring harness, pins
Driver PWB (A2)
NOTE: Tag 3 must be installed for
this code. If not, disable the fault
detection using [10-35]
Xerographic module (A23)
Paper transport assembly (A21)
Driver PWB (A2)
RAP
NO
NO
NO
NO
NO
NO
Comp
Code
[0921-6]
[901]
[1034]
[1033]
[1033]
[0701]
BSD Ref
9.7
9.7
10.2
10.2
10.2
7.5
PL
Ref
PL 9.9
PL 1.3
PL 9.9
PL 1.3
PL 10.4
PL 10.4
PL 10.4
PL 1.1
1/98
1-13
Status Code Entry Chart

Xerox 8830 Specifications

General

Brand	Xerox
Model	8830
Category	Printer
Language	English