Xerox 8830 Service Manual

3.
4.
5.
6.
7.
8.
Close the Media Transport Cover.
Open the Media Drawers (3) and remove the
packaging material from the Media Tubes.
Remove the Scorotron from the Media
Drawer and carefully remove the packing
material from the Scorotron.
Lift and rotate the image Module to the
Service Position. Install the Scorotron on the
Image Bar, making sure that the connector
end of the Scorotron is to the left (machine
rear).
Attach the connectors to the Scorotron,
taking care to join like-sized connectors.
(Figure 5): Remove the shipping pads
located near the ends of the Image Module.
9. (Figure 6): Disengage the Developer
Module shipping brackets.
Image Module at
Service Position
1
Remove the shipping
pads, one from each
end of drum
Remove the foam
pads, one from each
side
Figure 5. Removing the Shipping Pads
Slide bracket off
shaft
13. (Figure 7): Prepare to remove the
Developer Module.
1
Disconnect A22
R3016K
Repeat steps 1 through Retighten screw
3 on other side
Figure 6. Disengaging the Shipping
Brackets
10. Close the Image Module and the Top Cover.
11. Open the Developer Module door.
12. Remove the Toner Cartridge from the
Developer Module.
R3017K
Developer Module
Press in and rotate
the Developer
Module Retaining
Clip to the DOWN
position
Figure 7. Preparing to Remove the
Developer Module
8830
1/98
6-17 Installation

Xerox 8830 Specifications

General

Brand	Xerox
Model	8830
Category	Printer
Language	English