Xerox 8830 Service Manual

35. Install the Second Language EPROM on the
Main PWB (if required).
36. Install the Catch Tray or Folder. Refer to
Section 8 for Folder Installation Instructions.
NOTE: The 8830 Printer comes with either a
plain cover to attach to the right side of the
Printer or the 8830 Controller.
37. If the Printer you are installing does not have
the 8830 Controller (plain cover), perform
the following:
a. Attach the ribbon cable affixed to the
Side Cover to A1P3 on the Main PWB.
b. Place the Side Cover into the groove at
the bottom of the Printer and secure it
with the two screws provided.
38. If the Printer you are installing has the 8830
Controller, perform the following:
a. Connect the 8830 Controller ribbon
cable to J307B on the Main PWB.
b. Connect A1J3 on the 8830 Controller
panel to A1P3 on the Main PWB.
c. Attach the 8830 Controller to the Printer
by sliding it into the groove at the bottom
of the Printer and secure it with the two
screws provided.
Functional Checks:
1. Connect the Power Cord.
2. Switch on the Printer and enter the
Diagnostic mode.
CAUTION
When starting to operate the Printer, do not run
9-21-6. The Developer Material in this machine
has already been initialized. There is no need to
run this program again.
3. Refer to the Service Manual and perform the
following adjustments.
Country configuration (ADJ 3.2)
Initialize the Web Oiler [1030]
Vertical Magnification (ADJ 8.1)
Lead Edge Registration (ADJ 8.2)
Cut Length (ADJ 8.3)
Electrostatic Series (ADJ 9.2)
4. Make three test prints using [9-55-5] and [9-
55-7].
5. Check the print quality using Section 3 of
this Service Manual.
6. If there is a controller installed, run a test
print from the controller (special test).
7. Exit the Diagnostic mode.
8. Inform the operator that the following
adjustments are Operator Adjustments and
can be changed to fit individual needs. Refer
to the User Guide and demonstrate the
following adjustments.
• Power Saver Mode (EO: Low Power
Mode)
Standby Mode
Timers
Audible indicators
Print density
Controller (if present): Settings, Menu,
Printing a Test Pattern
9. Place a print of the Configuration Sheet
inside the Front Door.
8830
1/98
6-23
Installation

Xerox 8830 Specifications

General

Brand	Xerox
Model	8830
Category	Printer
Language	English