EasyManuals Logo

Xerox 8830 Service Manual

Xerox 8830
629 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #446 background imageLoading...
Page #446 background image
1. Check to ensure that the latest software is available and compatible for installation on all
components of the 8830 Digital Documents System. Reference the Configuration Matrix
Technical Services Bulletin (TSB) for the 8830 DOS product configuration, or reference
the Bulletin Board System (BBS).
2. II the 7356 Scanner is already Installed, proceed to the next step. If the scanner Is not
installed, perform the following before proceeding:
(Figure 1): Prepare the Scanner for Installation.
a.
Open the Top Cover
B
Remove the two foam pads from
the handles on the Document
Hold Down Guide
Lift out the Docu-
ment Hold Down
Guide
Remove the long paper strip from the platen glass
Remove the short
paper strip
Platen Glass
Edge Registered
Sensor
Edge Present
Sensor
O00KM5A-COB
Figure 2 Sensors and Platen Glass
c. Check the Platen Glass and the Document Hold down for damage or dirt and clean
the parts If dirt is found.
NOTE: Use Lena and Mirror Cleaner 43P81.
d. Install the Document Hold Down Guide.
e. Close the Top Cover.
Figure 1 Removing the Packing Material
(Figure 2): Ensure that the Edge Present Sensor and the Edge Registered Sensor
actuate and deactuate freely.
General Procedures
8830 DDS Installation
3/98
6-20
8830 DDS
A

Table of Contents

Other manuals for Xerox 8830

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Xerox 8830 and is the answer not in the manual?

Xerox 8830 Specifications

General IconGeneral
BrandXerox
Model8830
CategoryPrinter
LanguageEnglish

Related product manuals