c (Figure 5): Install the 8830 DDS Control Panel on the 7356 scanner.
NOTE: In the following step, ensure that the location of the Cable Guides is mea-
sured and lightly indicated in pencil on the rear of the scanner prior to installation of
the Cable Guides. Due to the strength of the adhesive used to hold the guides in
place, they must be positioned correctly the first time.
Align holes in bracket
with holes in scanner
cover
install the two remaining nuts
and screws and fully tighten
NOTE: When Installing the Cable Guides, make sura that the Quids Openings are
directed towards the center of the scanner. This gives the Cable guides a seamless
appearance and loosens the possibility of them catching on clothing.
d. (Figure 7): Install the Cable Guides and route the Control Panel Cable.
Route the Control Panel Cable through the
Cable guides
Install center screw com-
pletely, prior to mounting
other screws.
While holding center screw
and Control Panel in place,
raise the scanner cover
slightly
Install nut on center
screw and hand tighten
Figure 5 Rear view of 8830 DDS Control Panel showing fastener alignment
Door Seam
.25 inches
(6.36mm)
Align the edge of the Cable Guide
with the edge of the Control Panel.
Center and mount the Cable Guide
to the rear side of the Top Cover
Install Cable Guide a quarter inch
(6.35mm) to the right of the door
Figure 7 Rear of Scanner showing positioning of Cable Guides
Guide Opening
Adhesive Backing
Figure 6 7356 Scanner Cable Guide
General Procedures
8830 DDS installation
a/98
6-22
8830 DDS
A
E
To Next Page
Loading...
