(Figure 8): Install the Strain Reliefs and route the scanner cables through them.
A
Position Strain
Reliefs as
shown. Remove
adhesive back-
ing and secure
to scanner frame
B
Route SCSI and
Control Panel
Cables through
Strain Reliefs
Figure 8 Location of Strain Reliefs and routing of scanner cables
f. Locate the Control Panel labels (3) in the nationalization Kit.
g. Apply the Control Panel Labels to their respective positions on the 8830 DOS Con-
trol Panel. (Each label has its own unique shape and cutout configuration.)
h. Install the Document Loading Bins and Document Catch Tray kit per instructions in
that kit. (Instructions Included in box.)
If the 8830 printer has already been installed, proceed to the next step. Otherwise, per-
form the 8830 Printer Installation procedure in Section 8 of the 8830 Printer Service Man-
ual before proceeding.
5. If the 8830 has a Controller already installed, proceed to the next step. If the 8830 does
not have a Controller Installed, perform the following before continuing:
a. Take the uninstalled 8830 Controller from Its packaging and place it on the ground
behind the 8830 Printer. Power off the 8830 Printer. Attach all connectors to the
printer, and run a configuration test print from the printer (see 8830 Controller Ser-
vice Manual, Section 2.) The Information generated in this print will be needed later
in this Installation procedure.
b.
Disconnect the 8830 Controller and place it on an ESD mat. Continue with this pro-
cedure.
6. Check to see If the 8830 Controller Tags 5 and 6 have been installed. If not, perform the
procedure in Technical Service Bulletin TSB 97047. It will be necessary to perform this
procedure prior to proceeding to the next step.
NOTE: If the 8830 Controller you are working with begins with serial number F5Y, con-
tinue on with this 8830 Controller configuration update. If the serial number on your Con-
troller begins with is a number later than F5Y, then it has already been updated at the
factory. In this case, proceed to step 8
7. Install the upgrade kit (tags 7 and 8). (Procedure is located later in this chapter.)
8. If the 8830 Controller has not been Installed up to this point, install It now. Procedure can
be found in the 8830 Controller Manual, Section 6.
NOTE: It Installing a new 8830 Controller, you may find some duplication of parts with
regard to the upgrade kits. If so. discard the extra parts and continue on with this Installa-
tion procedure.
8630 DDS
3/96
6-23
General Procedures
8830 DDS Installation
4.
To Next Page
Loading...
