April 2010
6-39
Phaser 3635MFP/WorkCentre 3550
dC131
General Procedures/Information
20-220 Auto Dial Start
Pause Time
Pause time before auto-
dialing (second)
0 to 10 seconds 1
20-300 Ring On Time Ring on time. 90 to 800msec. 90
20-310 Ring Off Time Ring off time. 90 to 800msec. 90
20-320 Ring Detection
Freq
Call indication fre-
quency range.
12 to 80Hz (1)
16 to 55Hz (2)
20 to 55hz (3)
22 to 55hz (4)
1
20-400 DTMF High-Freq
Level
DTMF high frequency
level.
0 to 15dBm 8
20-410 DTMF Low-Freq
Level
DTMF low frequency
level.
0 to 15dBm 11
20-420 DTMF Timing DTMF duration of on/off
output.
80/80 (1)
70/70 (2)
70/150 (3)
60/60 (4)
80/100 (5)
150/50 (6)
150/240 (7)
5
20-500 Dial Mode Dial mode selection. Tone (0) / Pulse (1) 0
20-510 ECM Mode ECM mode on or off. Off (0)
On (1)
0
20-520 Error Rate Adjusts the error rate. Off (0) / 5% (1) / 10% (2) /
20% (3)
2
20-530 Dial Tone Detect Detects dial tone prior to
sending.
Off (0)
On (1)
0
20-540 Loop Current
Detect
Detects if loop current is
present prior to sending.
Off (0)
On (1)
0
20-550 Busy Signal
Detect
Detects a busy signal to
allow redials.
Off (0)
On (1)
0
20-700 Line Monitor
Setting
Audio line monitor. Off (0)
On (1)
Comm (2)
0
Table 10 NVM chain 20
Location NVM Name NVM Description Value Default
20-800 Modem Speed Select modem start
speed.
Modem_V21_300bps (0)
Modem_V27_2400bps (1)
Modem_V27_4800bps (2)
Modem_V29_7200bps (3)
Modem_V29_9600bps (4)
Modem_V33_12000bps (5)
Modem_V33_14400bps (6)
Modem_V17_7200bps (7)
Modem_V17_9600bps (8)
Modem_V17_12000bps (9)
Modem_V17_14400bps (10)
Modem_V34_2400bps (11)
Modem_V34_4800bps (12)
Modem_V34_7200bps (13)
Modem_V34_9600bps (14)
Modem_V34_12000bps (15)
Modem_V34_14400bps (16)
Modem_V34_16800bps (17)
Modem_V34_19200bps (18)
Modem_V34_21600bps (19)
Modem_V34_24000bps (20)
Modem_V34_26400bps (21)
Modem_V34_28800bps (22)
Modem_V34_31200bps (23)
Modem_V34_33600bps (24)
24
20-810 Fax Transmis-
sion Level
Adjusts the fax transmis-
sion level
0 to 15dBm 12
20-830 Auto Dial Time-
out
Adjusts the auto dial tim-
eout
30 to 150 seconds 55
20-840 FAX Batch Send
Enable
Fax batch send enable Off (0)
On (1)
0
20-900 FAX Total Send
Counter
Total of sent fax pages. (Read only) 0
20-910 FAX Total
Receive Counter
Total of received fax
pages.
(Read only) 0
Table 10 NVM chain 20
Location NVM Name NVM Description Value Default