Xerox WorkCentre 3550 - Page 60

April 2010
2-51
Phaser 3635MFP/WorkCentre 3550
OF4, OF5
Status Indicator RAPs
OF4 Copying Error RAP
Use this RAP if the machine does not copy correctly when the customer uses features such as
auto size detect, edge erase, book copying and image shift.
Procedure
WARNING
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
1. (3635 Only). Perform the Scan Edge test, GP 18 Scan Edge (3635 Only).
2. Clean the document glass (3635) PL 14.10 Item 27 or (3550) PL 14.11 Item 3.
3. Install a new scanner cover,
• (3635) Scanner cover, PL 14.10 Item 20.
• (3550) Scanner cover, PL 14.11 Item 1.
OF5 Stapler Fault RAP
Use this RAP if the stapler fails to operate.
Procedure
WARNING
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
Refer to Wiring Diagram 9 (3635).
1. Check the stapler door interlock switch, go to 01-700 Stapler Door Open RAP.
2. Check the wiring between CON1 on the stapler and CN4 on the Connection PWB.
3. Open the stapler door, PL 28.10 Item 9. Check that the paper present switch actuator
moves freely and actuates the paper present switch.
4. Install new components as necessary:
• Stapler, PL 11.10 Item 3.
• Connection PWB, PL 3.10 Item 17.