Xinje XD Series User Manual

113
< Written of single word >
D0FWRT FD0
X0
S· D·
<Written of double words>
D0DFWRT FD0
X1
S· D·
<Written of four words>
<Written of multi-word>
Write value from D0, D1, D2 to FD0, FD1,FD2
NOTE:
※1: FWRT instruction only can write data into FlashROM register. FlashROM can keep the
data even the power supply is off. It can store the important technical parameters.
※2: Written of FWRT needs a long time, about 500ms, so frequently write-in is not
recommended
※3: The written time of FlashROM is about 1,000,000 times. So we suggest using edge
signal (LDP, LDF etc.) to activate the instruction.
※4: Frequently write-in will damage the FlashROM.
4-5-9 Zone set [MSET]
1)Summary
Set the soft element in certain range
Multi-set [MSET]
16 bits
MSET
32 bits
-
Execution
condition
Normally ON/OFF; falling or
rising pulse edge signal
Suitable
Models
XD, XL
Hardware
requirement
-
Software
requirement
-
Write value from D0 to FD0
Write value from D0,D1 to FD0,FD1
D0FWRT FD0
X2
K3
S· D1·
D2·
Write value from D0,D1,D2,D3to FD0,FD1,FD2,FD3.
tudonghoatoancau.com

Xinje XD Series Specifications

General

Input Voltage	24V DC
Storage Temperature	-20°C to 70°C
Protection Class	IP20
Type	PLC
Series	XD
Programming Language	Ladder Logic, Instruction List
Communication Interface	RS232, RS485
Power Supply	24V DC
Digital Inputs	Available (number varies by model)
Digital Outputs	Available (number varies by model)
Analog Inputs	Available (number varies by model)
Analog Outputs	Available (number varies by model)
Output Type	Relay, Transistor
Number of Inputs	Varies by model (see Digital Inputs and Analog Inputs)
Number of Outputs	Varies by model (see Digital Outputs and Analog Outputs)
Operating Temperature	0°C to 50°C
Humidity	5% to 95% (non-condensing)