Xinje XD Series User Manual

43
The time value is stored in register TD. The working mode of timer T0~T575 and HT0~HT95
are 16-bits linear increasing. The time range is from 0 to 32767. When the time value in TD
reaches 32767, the timer will stop timing and keep the status.
MOV T0 D0
X0
MOV TD0 D0
X0
The two instructions are the same. In the first instruction, T0 is seemed to TD0.
X0
Y0
X0
X0
Y0 T2
T2
TMR T2 K200 K10
Y0
X0 is ON, output Y0. X0 changes from ON to OFF, delay 2s then cut off Y0.
X0
T1
T2
X0
Y0
T1 T2 T1
Y0
TMR T1 K20 K10
TMR T2 K10 K10
X0 is ON, Y0 begin to twinkle. T1 is Y0-OFF time; T2 is Y0-ON time.
Note: The range of soft components mentioned above is the valid range of PLC in the X-NET
communication mode. In the MODBUS communication mode, some relays can not read and
write. The specific usable range is shown in chapter 6-2-3.
2-8 Counter ( C, HC, HSC)
Number list
Application
Output delay
Twinkle
tudonghoatoancau.com

Xinje XD Series Specifications

General

Input Voltage	24V DC
Storage Temperature	-20°C to 70°C
Protection Class	IP20
Type	PLC
Series	XD
Programming Language	Ladder Logic, Instruction List
Communication Interface	RS232, RS485
Power Supply	24V DC
Digital Inputs	Available (number varies by model)
Digital Outputs	Available (number varies by model)
Analog Inputs	Available (number varies by model)
Analog Outputs	Available (number varies by model)
Output Type	Relay, Transistor
Number of Inputs	Varies by model (see Digital Inputs and Analog Inputs)
Number of Outputs	Varies by model (see Digital Outputs and Analog Outputs)
Operating Temperature	0°C to 50°C
Humidity	5% to 95% (non-condensing)