Xinje XD Series User Manual

218
In this panel, we can configure the parameters related to high speed count interruption. Take
the settings in above figure as an example to explain each parameter function.
Parameter
Function
single phase 100
segments high speed
counting
High Speed Counting in Single Phase
Incremental Mode
100 segments AB
phase high speed
counting
High Speed Counting in AB phase
mode
HSC0~HSC18(32-
bit)
High-speed counter number
corresponding to high-speed input
port
Free to specify
HSC0 is ON when the count value is
equal to the value in the register.
Free to specify
When it counts to the comparison
value, HSC0 is ON, the comparison
value can be set here or put in
compare reigster D500.
Relative
It will produce the interruption of
segment N when the counting value =
segment N-1 interruption counting
value + segment N setting value.
Absolute
It will produce the interruption when
the counting value is equal to setting
value.
Free to specify
The set values of 100 segments of
high-speed counting interrupts are
tudonghoatoancau.com

Xinje XD Series Specifications

General

Input Voltage	24V DC
Storage Temperature	-20°C to 70°C
Protection Class	IP20
Type	PLC
Series	XD
Programming Language	Ladder Logic, Instruction List
Communication Interface	RS232, RS485
Power Supply	24V DC
Digital Inputs	Available (number varies by model)
Digital Outputs	Available (number varies by model)
Analog Inputs	Available (number varies by model)
Analog Outputs	Available (number varies by model)
Output Type	Relay, Transistor
Number of Inputs	Varies by model (see Digital Inputs and Analog Inputs)
Number of Outputs	Varies by model (see Digital Outputs and Analog Outputs)
Operating Temperature	0°C to 50°C
Humidity	5% to 95% (non-condensing)