YASKAWA DX100 - Page 167

8Alarm
DX100 8.3 Alarm Message List
8-52
YIF board failure (1)Turn the power OFF then back ON.
(2)If the alarm occurs again, replace the YIF01 board. Save the CMOS.BIN
before replace the board to be safe. Replace the YIF01 board, and then load
the CMOS.BIN saved before alarm occurred.
15 The SVS parameter is damaged. Data error (1)Turn the power OFF then back ON.
(2)If the alarm occurs again, initialize the appropriate data in maintenance
mode, and then load the data saved in the external memory device.
YIF board failure (1)Turn the power OFF then back ON.
(2)If the alarm occurs again, replace the YIF01 board. Save the CMOS.BIN
before replace the board to be safe. Replace the YIF01 board, and then load
the CMOS.BIN saved before alarm occurred.
0210 MEMORY
ERROR(SYSTEM
CONFIG-DATA)
The system configuration
information data are damaged.
YCP01 board failure (1)Turn the power OFF then back ON.
(2)If the alarm occurs again, replace the YCP01 board. Save the CMOS.BIN
before replace the board to be safe. Replace the YCP01 board, and then
remove the CF from the failure YCP01 board to insert it into the new YCP01
board.
YIF board failure (1)Turn the power OFF then back ON.
(2)If the alarm occurs again, replace the YIF01 board. Save the CMOS.BIN
before replace the board to be safe. Replace the YIF01 board, and then load
the CMOS.BIN saved before alarm occurred.
0220 MEMORY
ERROR(JOB MNG
DATA)
0 The management data of job files
are damaged.
Data error (1)Turn the power OFF then back ON.
(2)If the alarm occurs again, initialize the job file in maintenance mode, and
then load the data (job, variable data, Robot calibration data) saved in the
external memory device.
Alarm
Number
Alarm Name Sub
Code
Meaning Cause Remedy