YASKAWA DX100 Service Manual

2 Security System
DX100 2.1 Protection Through Security Mode Settings
2-4
PARAMETER S1CxG Management Management
S2C Management Management
S3C Management Management
S4C Management Management
A1P Management Management
A2P Management Management
A3P Management Management
A4P Management Management
RS Management Management
S1E Management Management
S2E Management Management
S3E Management Management
S4E Management Management
SETUP TEACHING COND Edit Edit
OPERATE COND Management Management
DATE/TIME Management Management
GRP COMBINATION Management Management
RESERVE JOB NAME Edit Edit
USER ID Edit Edit
SET SPEED Management Management
KEY ALLOCATION
1)
Management Management
RES. START (CNCT) Management Management
ARC WELDING ARC START COND. Operation Edit
ARC END COND. Operation Edit
ARC AUX COND. Operation Edit
POWER SOURCE COND. Operation Edit
ARC WELD DIAG. Operation Edit
WEAVING Operation Edit
HANDLING HANDLING DIAGNOSIS Operation Edit
SPOT WELDING WELD DIAGNOSIS Operation Edit
I/O ALLOCATION Management Management
GUN CONDITION Management Management
POWER SOURCE COND Management Management
Table 2-2: Menu & Security Mode (Sheet 3 of 4)
Main Menu Sub Menu Allowed Security Mode
DISPLAY EDIT

YASKAWA DX100 Specifications

General

Programming Language	Inform III
Compatible Robots	Motoman robots
Operating Temperature	0-45°C
Humidity	20-80% RH (non-condensing)
Protection Class	IP20
Interface	Ethernet
Safety Standards	ANSI/RIA R15.06-1999
Pendant	Available
I/O Capacity	1024 inputs / 1024 outputs
Storage Temperature	-10-60°C