YASKAWA DX100 - Page 703

9Error
DX100 9.1 Error Message List
9-8
2270 - Cannot insert any more instruction in
JOB
2280 * JOB memory is full
1 Lack of position file memories
2 Lack of JOB registering memories
3 Lack of instruction file memories
4 Lack of memory pool
5 Lack of pass condition file for multi layer
2290 - Undefined master JOB
2291 * Undefined SUB Master JOB
1 Sub-master 1
2 Sub-master 2
3 Sub-master 3
4 Sub-master 4
5 Sub-master 5
6 Sub-master 6
7 Sub-master 7
8 Sub-master 8
2292 - Undefined MASTER START JOB
2293 * Undefined SUB START JOB
1 Sub-master 1
2 Sub-master 2
3 Sub-master 3
4 Sub-master 4
5 Sub-master 5
6 Sub-master 6
7 Sub-master 7
8 Sub-master 8
2300 - Cannot teach JOB without group-axis
specification
2310 * Same label exists
XXX Line no.
2320 - Cannot create coordinated JOB
2330 - Cannot edit coordinated instruction
2350 - Pasted data not found
2340 - Editing data not found
2360 - Cannot create editing area
2370 - Cannot cut/copy NOP and END
instructions
2380 - Wrong JOB selection
Error No. Data Error Message Contents