YASKAWA SVC - Page 542

10.5 Motion Parameter Details
10.5.2 Setting Parameter List
10-40
OW0E
Auxiliary Out-
put Data
Option
Selection
Bit 0: Torque Compensa-
tion (Option)
0: Disabled, 1: Enabled
When this bit is set to 1 (enabled), the output data
option Torque Compensation (OW13) will be
enabled when the Inverter I/O Control subcom-
mand is executed.
Bit 1: Analog Output Ter-
minal 1 Output
0: Disabled, 1: Enabled
When this bit is set to 1 (enabled), the output data
option Analog Output Terminal 1 Output
(OW14) will be enabled when the Inverter I/O
Control subcommand is executed.
Bit 2: Analog Output Ter-
minal 2 Output
0: Disabled, 1: Enabled
When this bit is set to 1 (enabled), the output data
option Analog Output Terminal 2 Output
(OW15) will be enabled when the Inverter I/O
Control subcommand is executed.
Bit 3: Terminal Output
0: Disabled, 1: Enabled
When this bit is set to 1 (enabled), the output data
option Terminal Output (OW16) will be
enabled when the Inverter I/O Control subcom-
mand is executed.
Bit 4: PID Target
0: Disabled, 1: Enabled
When this bit is set to 1 (enabled), the output data
option PID Target (OW17) will be enabled
when the Inverter I/O Control subcommand is exe-
cuted.
Bit 5: Pulse Train Output
0: Disabled, 1: Enabled
When this bit is set to 1 (enabled), the output data
option Pulse Train Output (OW18) will be
enabled when the Inverter I/O Control subcom-
mand is executed.
Bit 6: V/f Gain
0: Disabled, 1: Enabled
When this bit is set to 1 (enabled), the output data
option V/f Gain (OW19) will be enabled when
the Inverter I/O Control subcommand is executed.
Bit 7 Reserved
Bit 8: Command Selec-
tion
0: Disabled, 1: Enabled
When this bit is set to 1 (enabled), the output data
option Command Selection (OW1B) will be
enabled when the Inverter I/O Control subcom-
mand is executed.
Bits 9 to F Reserved
Continued on next page.
Continued from previous page.
Register No. Name Description