YASKAWA SVC - Page 548

10.5 Motion Parameter Details
10.5.2 Setting Parameter List
10-46
OW6C Transmission Reference Output Data 12
Setting range: 0 to FFFFH
This data is sent as the 13th word in the command
(main command bytes 24 and 25) when the Trans-
mission Reference command is executed.
OW
6D Transmission Reference Output Data 13
Setting range: 0 to FFFFH
This data is sent as the 14th word in the command
(main command bytes 26 and 27) when the Trans-
mission Reference command is executed.
OW
6E Transmission Reference Output Data 14
Setting range: 0 to FFFFH
This data is sent as the 15th word in the command
(main command bytes 28 and 29) when the Trans-
mission Reference command is executed.
OW
6F Transmission Reference Output Data 15
Setting range: 0 to FFFFH
This data is sent as the 16th word in the command
(main command bytes 30 and 31) when the Trans-
mission Reference command is executed.
OW
70 Transmission Reference Output Data 16
Setting range: 0 to FFFFH
This data is sent as the 1st word in the subcom-
mand (subcommand bytes 0 and 1) when the
Transmission Reference subcommand is executed.
Note: Enabled only in 64-byte Mode.
OW71 Transmission Reference Output Data 17
Setting range: 0 to FFFFH
This data is sent as the 2nd word in the subcom-
mand (subcommand bytes 2 and 3) when the
Transmission Reference subcommand is executed.
Note: Enabled only in 64-byte Mode.
OW72 Transmission Reference Output Data 18
Setting range: 0 to FFFFH
This data is sent as the 3rd word in the subcom-
mand (subcommand bytes 4 and 5) when the
Transmission Reference subcommand is executed.
Note: Enabled only in 64-byte Mode.
OW73 Transmission Reference Output Data 19
Setting range: 0 to FFFFH
This data is sent as the 4th word in the subcom-
mand (subcommand bytes 6 and 7) when the
Transmission Reference subcommand is executed.
Note: Enabled only in 64-byte Mode.
OW74 Transmission Reference Output Data 20
Setting range: 0 to FFFFH
This data is sent as the 5th word in the subcom-
mand (subcommand bytes 8 and 9) when the
Transmission Reference subcommand is executed.
Note: Enabled only in 64-byte Mode.
OW75 Transmission Reference Output Data 21
Setting range: 0 to FFFFH
This data is sent as the 6th word in the subcom-
mand (subcommand bytes 10 and 11) when the
Transmission Reference subcommand is executed.
Note: Enabled only in 64-byte Mode.
OW76 Transmission Reference Output Data 22
Setting range: 0 to FFFFH
This data is sent as the 7th word in the subcom-
mand (subcommand bytes 12 and 13) when the
Transmission Reference subcommand is executed.
Note: Enabled only in 64-byte Mode.
OW77 Transmission Reference Output Data 23
Setting range: 0 to FFFFH
This data is sent as the 8th word in the subcom-
mand (subcommand bytes 14 and 15) when the
Transmission Reference subcommand is executed.
Note: Enabled only in 64-byte Mode.
Continued on next page.
Continued from previous page.
Register No. Name Description