YOKOGAWA SL1400 - Page 345

11-27
IM 701240-01E
Waveform Analysis/Search
3
2
1
4
5
6
7
8
9
10
11
11
12
13
14
15
16
17
18
App
Index
Setting the 1 Cycle Mode
18. Press the 1Cycle Mode soft key to select ON or OFF.
Setting the Measurement Range
19. Press the Time Range1/Time Range2 soft key to set the jog shuttle control to
Time Range1.
20. Turn the jog shuttle to set the measurement start point.
21. Likewise, set Time Range2 (measurement end point).
Note
Up to 10 MW from the measurement start point (Time Range1) are measured.
Selecting the Target Waveform for Distal, Mesial, and Proximal Points
22. Press the Next 1/2 soft key
23. Press the Trace soft key. The trace selection menu appears.
24. Press the soft key corresponding to the desired waveform to select the target
waveform.
Setting the Distal, Mesial, and Proximal Unit
25. Press the Dist/Prox Mode soft key to set the unit for distal, mesial, and proximal
points to % or Unit.
Setting Distal, Mesial, and Proximal
26. Press the Distal, Mesial, or Proximal soft key.
27. Turn the jog shuttle to set the distal, mesial, or proximal point.
Selecting the High and Low Setting
28. Press the High/Low Mode soft key to select Auto or MAX-MIN.
11.5 Automated Measurement of Waveform Parameters