11-26
IM 701240-01E
Setting the Delay
8. Press the Delay Setup soft key. The Delay Setup dialog box appears.
• Selecting the Waveform to Be Measured
9. Press the Trace soft key. The trace selection menu appears.
10. Use jog shuttle+SELECT to select waveform to be measured.
• Setting the Delay
11. Use jog shuttle+SELECT to set Mode of the Delay Setup dialog box to Time,
Degree, or OFF.
12. Use jog shuttle+SELECT to set Polarity under Measure to
(rising edge) or
(falling edge).
13. Use jog shuttle+SELECT to set Edge Count under Measure.
14. Use jog shuttle+SELECT to select whether the trace or the trigger is to be the
reference. If you select Trace, proceed to step 15.
15. Use jog shuttle+SELECT to set Trace under Reference.
16. Use jog shuttle+SELECT to set Polarity under Reference to
(rising edge) or
(falling edge).
17. Use jog shuttle+SELECT to set Edge Count under Reference.
11.5 Automated Measurement of Waveform Parameters
To Next Page
Loading...
