13-44
IM 701240-01E
Specifying the Print Settings
9. Press the Print Setup soft key. The print setup dialog box opens.
When displaying T-Y waveforms, proceed to step 10.
When displaying X-Y waveforms, proceed to steps 15 to 18 and then 24.
Setting the Print Format
10. Use jog shuttle+SELECT to select the format from 1 Zone to 16 Zone.
Note
The print format setting is linked with the DISPLAY menu > Format setting.
Setting the Extra Area (Only When Displaying the T-Y Waveform)
11. Use jog shuttle+SELECT to turn the extra area ON or OFF.
Setting the Flexible Zone (Only When Displaying the T-Y Waveform)
12. Use jog shuttle+SELECT to select Setup in Flexible Zone.
13. Use jog shuttle+SELECT to set the mode to OFF or ON.
14. Use jog shuttle+SELECT to set the upper and lower limits of the waveform to
be recorded.
Setting the Graticule
• Setting the Grid
15. Use jog shuttle+SELECT to set the type to
, OFF, or .
• Setting Dark/Light
16. Use jog shuttle+SELECT to set dark/light to light or dark.
• Setting the Width of the Vertical Scale
17. Use jog shuttle+SELECT to set the width to 1div or 10mm.
Note
The grid setting is linked with the DISPLAY menu > Graticule setting. However, if OFF is
selected, the DISPLAY menu is set to .
When Displaying the T-Y Waveform When Displaying the X-Y Waveform
13.14 Creating PDF Files of the Printed Image
To Next Page
Loading...
