18-4
IM 701240-01E
Vertical and Horizontal Axes Settings
Item Specifications
Channel ON/OFF Independently turn ON/OFF CH1 to CH16, Logic A, and Logic B.
ALL CH menu Set all channels while displaying waveforms. Operation using the USB keyboard and USB mouse is
possible.
Vertical axis expansion/ Expand or reduce the vertical axis for each channel.
reduction
Variable Upper/Lower limit scaling when variable is ON.
Input filter Set for each channel.
Vertical position setting Waveforms can be moved vertically in the range of ±5 div from the center of the waveform display
frame.
Linear scaling Set AX+B mode or P1-P2 mode independently for CH1 to CH16.
Roll mode The roll mode is enabled when the trigger mode is set to auto, auto-level, single, or log, and the
record time is greater than or equal to 1 s.
Analysis
Item Specifications
Auto scroll Automatically scrolls the zoom position.
History search function Search for and display waveforms from the history memory that satisfy specified conditions.
Zone search: Set an area on the screen, then extract and display only those waveforms
that pass through the area or do not pass through the area.
Parameter search: Extract and display only the results of the automated measurement of
waveform parameters that meet the specified condition.
Cursor measurement The following cursors are selectable.
Horizontal, Vertical, H&V, Degree (only for T-Y waveform display), and Marker
Automated measurement of waveform parameters
Capable of performing automated measurement of waveform parameters. Automated measurement
of waveform parameters within one period (P-P through Int2XY).
Up to 24 items can be displayed.
P-P, Amp, Max, Min, High, Low, Avg, Mid, Rms, Sdev, +OvrShoot, –OvrShoot, Rise, Fall, Freq,
Period, +Width, –Width, Duty, Pulse, Burst1, Burst2, AvgFreq, AvgPeriod, Int1TY, Int2TY, Int1XY,
Int2XY, and Delay (between channels)
Statistical processing
Applicable items: Automated measured values of waveform parameters
described above.
Statistical items: Max, Min, Avg, Sdv, and Cnt
Maximum number of cycles: 48000 cycles (when the number of parameters is 1)
Maximum total number of parameters: 48000 (total number of results)
Maximum measurement range: 10 MW
Normal statistical processing
Performs statistical processing on all acquired waveforms while acquiring waveforms.
Cyclic statistical processing
Performs statistical processing per cycle (cyclic statistical computation). Extracts a periodic
waveform (cycle) from the acquisition memory and automatically calculates waveform parameters
per cycle.
Statistical processing of history data
Performs automated measurement of waveform parameters on the waveform that is acquired using
the history memory function and performs statistical processing.
Statistical processing is performed from the oldest data.
Computation Operators: +, –, ×, /, binary computation, phase shift, and power spectrum
Phase shift Monitor waveforms by shifting the phase of CH1 to CH16. Computation is performed on the phase-
shifted result.
* When the Ethernet interface option is installed
18.5 Function
To Next Page
Loading...
