8 - 14 DS457-XX20004ZZWW Fixed Mount Imager Integration Guide
Host Serial Response Time-out
Parameter # 155 (SSI # 9Bh)
This parameter specifies how long the imager waits for an ACK or NAK before resending. Also, if the imager
wants to send, and the host has already been granted permission to send, the imager waits for the designated
time-out before declaring an error.
To set the delay period (options are 2, 5, 7.5, or 9,9 seconds), scan one of the following bar codes.
NOTE Other values are available via SSI command.
*Low - 2 Seconds
(20)
Medium - 5 Seconds
(50)
High - 7.5 Seconds
(75)
Maximum - 9.9 Seconds
(99)
To Next Page
Loading...
Need help?
General
