Zebra DS457 Series - Boot Up Event; Parameter Event

SSI Interface 8 - 19
Boot Up Event
Parameter # 258 (SSI # F0h, 02h)
When enabled, the imager generates a message to the host whenever power is applied. When disabled, no
notification is sent.
Parameter Event
Parameter # 259 (SSI # F0h, 03h)
When enabled, the imager generates a message to the host when one of the events specified in Table 8-4 on
page 8-18 occurs. When disabled, no notification is sent.
Enable Boot Up Event
(1)
*Disable Boot Up Event
(0)
Enable Parameter Event
(1)
*Disable Parameter Event
(0)