Zebra DS457 Series User Manual

7 - 6 DS457-XX20004ZZWW Fixed Mount Imager Integration Guide
Decoding Illumination
Parameter # 298 (SSI # F0h 2Ah)
Selecting Enable Decoding Illumination causes the imager to turn on illumination every image capture to aid
decoding. Select Disable Decoding Illumination to prevent the imager from using decoding illumination.
Enabling illumination usually results in superior images. The effectiveness of illumination decreases as the
distance to the target increases.
Decode Aiming Pattern
Parameter # 306 (SSI # F0h 32h)
This parameter only applies in Decode Mode. Select Enable Decode Aiming Pattern to project the aiming
pattern during bar code capture, or Disable Decode Aiming Pattern to turn the aiming pattern off.
NOTE Changing this parameter while using Presentation Mode is not recommended.
*Enable Decoding Illumination
(1)
Disable Decoding Illumination
(0)
NOTE If Picklist Mode on page 6-17 is enabled, the decode aiming pattern turns on even when disabled.
*Enable Decode Aiming Pattern
(2)
Disable Decode Aiming Pattern
(0)

Zebra DS457 Series Specifications

General

Connectivity	USB, RS-232
Decode Capability	1D, 2D, PDF417, Postal Codes
Scan Rate	Up to 60 scans per second
Supported Barcode Types	UPC/EAN, Code 39, Code 128, QR Code, Data Matrix, PDF417, Postal Codes
Storage Temperature	-40°F to 158°F (-40°C to 70°C)
Humidity	5% to 95% (non-condensing)
Power Consumption	2.5 W (typical)