Zebra DS457 Series - Chapter 10 USB Interface; Introduction

CHAPTER 10 USB INTERFACE
Introduction
This chapter describes how to set up the imager with a USB host. The imager connects directly to a USB host,
or a powered USB hub, which powers it. No additional power supply is required.
Throughout the programming bar code menus, asterisks (
*) indicate default values.
*North American Standard USB Keyboard
Feature/Option
* Indicates Default
NOTE Most computer monitors allow scanning the bar codes directly on the screen. When scanning from the
screen, be sure to set the document magnification to a level where you can see the bar code clearly, and
bars and/or spaces are not merging.