Zebra DS457 Series - Power Mode (RS-232 Hosts Only); Time Delay to Low Power Mode

User Preferences 6 - 15
Power Mode (RS-232 Hosts Only)
Parameter # 128 (SSI # 80h)
Select whether or not the imager enters Low Power consumption mode after a decode attempt. In Continuous
On mode, the imager does not enter this low power state.
Time Delay to Low Power Mode
Parameter # 146 (SSI # 92h)
This parameter sets the time the imager remains active after decoding. After a scan session, the imager waits
this amount of time before entering Low Power mode.
Continuous On
(0)
*Low Power Mode
(1)
NOTE This parameter only applies when Power Mode is set to Low Power.
To program a different value for this parameter than those provided here, see Using Time Delay to Low
Power Mode with SSI on page 8-7.
*1 Second
(17)
5 Seconds
(21)