Zebra MC33 Series Integrator Guide

Settings
161
Figure 112 Choose Your Pattern Screen
6. Draw a pattern connecting at least four dots.
7. Touch Continue.
8. Re-draw the pattern.
9. Touch Confirm.
10. Select the type of notifications that appear when the screen is locked and then touch Done.
11. Touch . The next time the device goes into suspend mode a Pattern is required upon waking.
Passwords
To set the device to briefly show password characters as the user types:
Swipe down with two fingers from the status bar to open the quick access panel and then touch > Security.
Slide the Make passwords visible switch to the ON position.
Button Remapping
The MC33XX’s buttons can be programmed to perform different functions or shortcuts to installed applications.
• Grip Trigger
NOTE: It is not recommended to remap the scan button.

Zebra MC33 Series Specifications

General

Connectivity	USB 2.0, Bluetooth
Touch Panel	Capacitive, glove and wet touch support
Keypad Options	Touchscreen or physical keypad
Scanning	1D/2D barcode scanning
Wireless LAN	IEEE 802.11 a/b/g/n/ac
Operating Temperature	-20° C to 50° C